j.
Processor heat sink (see
k.
Display assembly (see
l.
Top cover (see
m. Speaker assembly (see
n.
System board (see
Remove the ExpressCard assembly:
1.
Turn the system board upside down, with the ExpressCard eject button toward you.
2.
Lift the Mylar covering up (1) to expose the screws that secure the assembly to the system board.
3.
Remove the two Phillips PM2.0×6.0 screws (2) that secure the ExpressCard assembly to the
system board.
4.
Turn the system board right-side up.
5.
Remove the two Phillips PM2.0×7.0 screws (1) that secure the ExpressCard assembly to the
system board.
Processor heat sink on page
Display assembly on page
Top cover on page
78)
Speaker assembly on page
System board on page
66)
70)
83)
85)
Component replacement procedures
89