Scanner Emulation Parameter Defaults
Table 11-1
lists the defaults for the Scanner Emulation host. To change any option, scan the appropriate bar
code(s) provided in the Scanner Emulation Host Parameters section beginning on
NOTE See
miscellaneous default parameters.
Scanner Emulation Default Table
Table 11-1
Parameter
Parameter Pass-Through
Convert Newer Code Types
Module Width
Convert All Bar Codes to Code 39
Code 39 Full ASCII Conversion
Transmission Timeout
Ignore Unknown Characters
Leading Margin
Check for Decode LED
1
User selection is required to configure this interface and this is the most common selection.
Scanner Emulation Host
Scan the bar code below to enable the Scanner Emulation host.
Undecoded Scanner Emulation Host
Appendix A, Standard Default Parameters
20 µs
Disable
3 sec
2 ms
Scanner Emulation Interface 11 - 3
page
for all user preferences, hosts, symbologies, and
Default
11-4.
Page Number
11-4
11-5
11-6
11-6
11-7
11-7
11-8
11-9
11-9
11-10