Starter Servicing - McCulloch MS1436NAV Service Manual

8.9. Remove the brass pump housing from the oil
pipe. See Figure 21.
NOTE: The small hole in the brass pump hous-
ing must be facing up into the upper oil hose dur-
ing assembly. The flats on the pump housing
align with the molded tabs on the housing.
NOTE: Replace the felt washer any time you
service the chain oiler. See Figure 22.
Felt Washer
8.10. Torque the nut securing the clutch drum assem-
bly to the crankshaft to during assembly.
Pump Housing
Figure 21
Figure 22
9.

STARTER SERVICING

9.1. Using a T-25 Torx wrench, remove the four
screws attaching the starter housing assembly to
the housing assembly. See Figure 23.
Torx Screws
9.2. Remove the housing from the unit.
9.3. Use a screwdriver to lift the starter cord from
around the pulley and unwind the starter cord.
This takes tension off the starter pulley. See Fig-
ure 24.
7
Figure 23
Starter Cord
Figure 24