Table of Contents
Advertisement
Memo :
The selectable languages vary according to the
0
destination.
The menus and messages on the screen of the
0
LCD monitor or viewfinder are displayed in the
selected language.
2 Move the cursor using the cross-shaped
button (JK) to select a language to use,
followed by pressing the Set button (R).
The Initial Setting screen appears.
Prior to the first operation,
try self diagnosis attaching
with lens cap.
The Time is about 6 minutes.
Diagnose
3 Ensure that the lens cover is closed, and
press the Set button (R).
Self-diagnosis starts.
0
A progress bar appears, and "Complete
0
Diagnosis" appears when the diagnosis is
complete.
Diagnosing...
Don't Remove Lens Cap.
Complete Diagnosis
Close
Memo :
It takes about 6 minutes to complete the
0
diagnosis. During the diagnosis, do not operate
or turn off the camera recorder.
4 Press the Set button (R) after confirming
the exit screen.
The [Initial Setting] screen appears.
For U models
0
Initial Setting
UTC-05:00
For E models
0
Initial Setting
UTC
Memo :
The [Initial Setting] screen appears when the
0
power is turned on for the first time and when the
power is turned on after the built-in battery is fully
discharged.
The configured date/time data is saved in the
0
built-in rechargeable battery even if the power is
turned off.
5 Set the time zone and date/time.
A Move the cursor with the cross-shaped button
(HI) and select the setting item.
B Change the values with the cross-shaped
button (JK).
6 Press the Set button (R) after setting is
complete.
The clock is set to 0 seconds of the input date/
time.
Memo :
The configured date/time data can be displayed
0
on the LCD monitor and viewfinder and be
recorded to the SD card.
The value of the year can be set in the range of
0
"2000" to "2099".
Changing the Time after Initial Setting
Setting the Date/Time
(A P131 [ Date/Time ] )
1 Select [System] B [Date/Time].
The [Date/Time] screen appears.
Set
Set
Initial Settings
35
Advertisement
Table of Contents
