Assembling Cleaner; Carton Contents - Hoover S3755050 Owner's Manual

1. Assembling cleaner

This cleaner was inspected and packaged carefully before being shipped
from the factory. If you should happen to need assistance during assembly
or operation,
Visit us online at www.hoover.com to find the service outlet nearest
you (click on the "Service" button) OR
Call 1-800-944-9200 for an automated referral of authorized service
outlet locations (U.S. only) OR
Call 1-330-499-9499 to speak with a representative in the Hoover
Consumer Response Center.

Carton contents

1-1
A
Connect hose, wand and nozzle
1-2
A
C
B
Connect hose
Push the hose connector end (A) into the
opening (B) on the front of the cleaner.
To disconnect hose from the cleaner,
press on the button (C) on the hose con-
nector and pull forward.
Note: The flexible hose contains elec-
trical wires for connection to the
power nozzle and should not be used
if damaged. The wires should not be
seen through the outer skin.
C
B
1-3
D
E
Attach wand and power
nozzle
Push the end of the wand with the
pronged plug (D) firmly into the end of
the hose until the latch (E) clicks.
To remove the wand from the hose,
press on the thumb latch (E) located on
the end of the wand.
Unpack cleaner from carton and iden-
tify the parts shown. Remove and
dispose of cardboard packing.
A. Canister cleaner
B. WindTunnel™ powered nozzle
C. Extension wand and hose
Operate cleaner only at voltage speci-
fied on data plate on bottom of
cleaner.
1-4
F
G
Push the opposite end of the wand into
the power nozzle until the button projec-
tion (F) on the end of the wand clicks.
To release, step on quick disconnect
foot pedal (G) and remove nozzle.
Continued
3