Toshiba W-707 Service Manual page 66

7. Remove the S, T loading lever assemblies (4) and (5).
8. When removing the pinch drive lever (6), first,
remove the cassette door guide, pinch assembly, and
the joint lever (Refer to item 1-6-13.), and then
remove the T reel table (Refer to item 1-6-11.).
Next, pull out the pinch drive lever (6) after turning
it counterclockwise from the bottom side of the
mechanical deck.
Pinch drive lever (6)
Fig. 1-6-19 Bottom side of mechanical deck
9. When removing the tension drive lever (7), first,
remove the S reel table (Refer to item 1-6-11.) Next,
turn the band brake mounting portion counterclock-
wise from the bottom side of the mechanical deck,
and then remove the tension drive lever (7) after
turning it clockwise.
Notes:
• When turning the band brake mounting portion, do it
by inserting a screwdriver into the rectangle hole. At
this time, pay attention not to bent it upward and
downward.
• After mounting, check the tension post position, and
perform the adjustment and the confirmation of the
back tension. (Refer to the section 1-7-1. Tension
Post Position Check, and 1-7-2. (2) Reel Torque
Check and Back Tension Check.)
Tension drive lever (7)
Rectangle hole
Fig. 1-6-20 Bottom side of mechanical deck
10. Replace each part with new one.
Apply an amount of grease on the following
portions of the new parts.
Fig. 1-6-21 Loading drive gear
Band brake
mounting portion
Apply grease to the
shaded portion
Narrow side
11. When mounting the S, T loading lever assembly (4)
and (5), align the marks.
T loading lever
assembly (5)
12. When mounting the cam slider (3), loading drive gear
(2), and the joint gear 2 (8), align the marks of the
marking portions.
Joint gear 1 (6)
Joint gear 2 (8)
Align marks.
Cam slider (3)
13. Mount each part in the reverse order of removal.
.
Apply grease to the
shaded portion
Fig. 1-6-22 Cam slider
Align marks.
S loading lever
assembly (4)
Fig. 1-6-23
T loading lever
assembly (5)
Loading drive gear (2)
S brake
assembly pin
Pin
T brake
(Tension drive lever)
assembly pin
Pin
(Pinch drive lever)
Fig. 1-6-24
.
Align marks.
Align marks.