Remote Control - Pioneer VSX-D710S Service Manual

VSX-D710S

Remote Control

SOURCE
1
2
DVD TV
MULTI CONTROL
3
RCV CD
1
MIDNIGHT
4
4
7
10
MPX
¶
7
5
BAND CLASS
1 ¡
2
/DTS DSP
6
CH SELECT CH LEVEL
7
LOUDNESS
FL DIMMER
8
TUNE
ST
ENTER
TUNE
CHANNEL
VOLUME
MENU
TVFUNC
9
TV CONTROL
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
1 SOURCE
button
Use to turn on/off other components connected to the
receiver.
2 MULTI CONTROL buttons
Use to put the receiver/remote control in the stated
mode.
For other equipment controls, see "Controlling the Rest
of Your System".
58
#
RECEIVER
@
VCR CD-R
TUN
TVC
2 3
5.1 / 7.1 ATT
5 6
EFFECT
8 9
!
0
DISC
D.ACCESS
3
8
DISPLAY RF ATT
4 ¢
TEST TONE SIGNAL SELECT
FUNCTION
MUTING
SETUP
ST
~
=
MASTER VOLUME
-
TV
0
3 RCV button
Use this button when setting up the surround sound for
the receiver. Also press it if you want to use special
features attached to some of the number buttons, for
example MIDNIGHT, 5.1/7.1, EFFECT +/− or ATT.
4 NUMBER/MODE buttons
Use the number buttons to select the radio frequency in
tuner DIRECT ACCESS mode or the tracks in CD, DVD
mode etc.
Also, buttons marked with the following names have
special functions. If you try to use one of these functions
but the display flashes it means that function cannot be
used in the current mode (for example DSP modes
cannot be used when 5.1 Ch setting is on).
MIDNIGHT button
Use to put receiver in MIDNIGHT mode. To use first press
the button then operate this button.
RCV
5.1/7.1 button
(VSX-D710S is 5.1 Ch)
When the DVD/LD or DVD 5.1/7.1 Ch function is selected
each press switches the DVD/LD input between DVD/LD
and DVD 5.1/7.1 Ch. To use first press the
then operate this button.
ATT button
When the overload indicator lights use this button to
attenuate (lower) the level of an analog input signal and
prevent distortion. To use first press the
operate this button.
EFFECT +/– buttons
Use to add or subtract the amount of effect in different
DSP sound modes (except 6 Ch Stereo) or advanced
listening modes.
To use first press the
RCV
buttons.
5 THE FOLLOWING BUTTONS ARE BOTH CONTROLS
FOR OTHER COMPONENTS (LIKE A DVD PLAYER)
AND DEDICATED TUNER CONTROLS. THE TUNER
CONTROLS ARE EXPLAINED HERE. YOU CAN USE
THEM AFTER YOU HAVE PUSHED THE TUNER MULTI
CONTROL BUTTON.
BAND button
Use to switch between the AM and FM band when in
TUNER mode.
CLASS button
Use to switch between the three banks (classes) of
station memories.
MPX button
Use to switch between auto stereo and mono reception of
FM broadcasts. If the signal is weak then switching to
MONO will improve the sound quality.
D. ACCESS button
Use to directly access a radio station by pressing the
number of the station you want.
DISPLAY button
Use to display the RDS information.
RF ATT button
Use to lower the input level of a radio signal that is too
powerful or contain interference thus causing the receiver
to distort.
button
RCV
button then
RCV
button then operate these