Panasonic KX-FT937LA-B Service Manual page 57

11.1.3. Service Function Table
Code Function
501 Pause time
502 Flash time
503 Dial speed select
510 VOX time
511 VOX sense
514 Bell detection time
520 CED frequency select
521 International mode select
522 Auto standby select
523 Receive equalizer select
524 Transmission equalizer select
533 Setting the number of time that mes-
sage transfer is redialed
534 Setting the message transfer/paper call
redial interval
544 Document feed position adjustment
value set
550 Memory Clear
551 ROM check
552 DTMF single tone test
553 Monitor on FAX communication select
554 Modem test
555 Scan check
556 Motor test
557 LED test
558 LCD test
559 Document jam detection select
560 Cutter selection
561 KEY test
562 Cutter test
570 BREAK % select
571 Setting the number of times that ITS is
redialed
572 ITS auto redial line disconnection time
set
573 Remote turn-on ring number set
580 TAM continuous tone detection
590 FAX auto redial time set
591 FAX auto redial time disconnection time
set
Set Value Effective
Range
X 100 msec 001~600
X 10 ms 01~99
1: 10 pps 1, 2
2: 20 pps
1:6 sec 2:4 sec 1, 2
1:High 2:Low 1, 2
X 10 msec 1~9
1: 2100 Hz 1, 2
2: 1100 Hz
1:ON 2:OFF 1, 2
1:ON 2:OFF 1, 2
1: 0 km 1~4
2: 1.8 km
3: 3.6 km
4: 7.2 km
1: 0 km 1~4
2: 1.8 km
3: 3.6 km
4: 7.2 km
00~99 00~99 03 times Selects the number of times that message transfer is
001~999 sec 001~999
1: 3 mm 1~5
2: 4 mm
3: 5 mm
4: 6 mm
5: 7 mm
1:ON 2:OFF 1, 2
1:OFF 1~3
2:PHASE B
3:ALL
1:ON 2:OFF 1, 2
1:ON 2:OFF 1, 2
1:61% 2:67% 1, 2
00~99 00~99
X second 001~999
X number of 01~99
rings
1:ON 2:OFF 1, 2
X number of 00~99
times
X second 001~999
57
Default
050 ----------
70 ----------
1 ----------
1 Setting of the end of call confirmation VOX.
1 When the TAM (or EXT TAM) does not stop recording
the ICM because noise is detected on the telephone
line, change this setting to "LOW".
6 ----------
1 See Symptom/Countermeasure Table for long distance
and international calls in The unit can copy, but can-
not transmit/receive (P.83).
1 See Symptom/Countermeasure Table for long distance
and international calls in The unit can copy, but can-
not transmit/receive (P.83).
1 The resolution reverts to the default when transmission
is complete.
1 When the telephone station is far from the unit or recep-
tion cannot be performed correctly, adjust accordingly.
1 When the telephone station is far from the unit or trans-
mission cannot be performed correctly, adjust accord-
ingly.
redialed (not including the firsttransfer is redialed (not
including the first.
065 sec Sets the interval of message transfer/pager call redial.
3 If it is difficult to feed documents, raise the set value. If
multi documents feed occurs, lower the set value.
See Memory Clear Specification (P.59).
See Test Mode (P.54).
2 See Test Mode (P.54).
1 Sets whether to monitor the line signal with the unit's
speaker during FAX communication or not.
See Test Mode (P.54).
See Test Mode (P.54).
00 See Test Mode (P.54).
See Test Mode (P.54).
See Test Mode (P.54).
1 Selects the jam detection of a document during FAX
transmission/copying.
1 Turns off the cutter function.
00 See Test Mode (P.54).
Press "SET" key.
1 Sets the % break of pulse dialing according PBX.
05times Select the number of times that ITS is redialed(not
including the first dial).
065 Sets the interval of ITS redialing.
10 Sets the number of rings before the unit starts to
receive a document in the TEL mode.
1 ON: Stops TAM operation when Dial tone, etc are
detected.
05 Selects the number of redial times during FAX commu-
nication (not including the first dial).
065 Sets the FAX redial interval during FAX communication.
KX-FT937LA-B
Remarks