Toshiba CN27E90 Technical Training Manual page 66

2-3. V Output
2-3-1. Circuit Operation
The V output circuit consists of a V driver circuit Q302,
Pump-up circuit and output circuit Q301, and external circuit
components.
(1) Q2 amplifies its input fed from pin 4 of Q301, Q3, Q4
output stage connected in a SEPP amplifies the current
and supplies a sawtooth waveform current to a deflection
Q301
Q2
4
(2) In Fig. 10-6 (a), the power Vcc is expressed as a fixed
level, and the positive and negative current flowing into
the deflection yoke is a current (d) = current (b) + (c) in
Fig. 10-6, and the emitter voltage of Q3 and Q4 is
expressed as (e).
(3) Q3 collector loss is i1 x Vce1 and the value is equal to
multiplication of Fig. 10-6 (b) and slanted section of
Fig. 10-6 (e), and Q4 collector loss is equal to
multiplication of Fig. 10-6 (c) and dotted section of Fig.
10-6 (e).
+27V
D301
D308
6 3
Q3
BIAS
CIRCUIT
Q4
1
Fig. 10-5 V output circuit
Power Vcc
Q3
i1
Q4
Q2
i2
(a) Basic circuit
Fig. 10-6 Output stage operation waveform
yoke. Q3 turns on for first half of the scanning period
and allows a positive current to flow into the deflection
yoke (Q3
turns on for last half of the scanning period and allows
a negative current to flow into the deflection yoke
(R305 C306
shown in Fig. 10-5.
C308
D309 R309
7
2
DY
C306
R305
Vce 1
66
1DY C306 R305 GND), and Q4
DY Q4). These operations are
V 3
V 7
V 2
Q3 ON
Q4 ON
GND (b) Q3 Collector current i1
GND (c) Q4 Collector current i2
GND (d) Deflection yoke current i1+i2
Vp
Vcc
(e)
1/2 Vcc
GND
50V
27V
GND
27V
GND
50V
GND
GND