Table of Contents
Advertisement
Useful Functions in Tape Operation (continued)
1
2
3
4
5
6
7
8
9
0
100
PLAY/x2
3
REW
FF
STOP
2
2 4
5
Press PROG. to exit.
6
Press REMAIN/COUNTER .
The remaining time ("RT - : - -") appears in the VCR display.
Notes
• The displayed remaining time is an approximation.
• The remaining time is calculated according to the tape speed (SP or SLP)
and the cassette type.
Index Search Function
The VCR can find a point where a registered index signal is on a
tape and play back for about 5 seconds. You can easily locate
the desired program by inputting the index signal.
2
Playback
Playback
for 5 sec.
for 5 sec.
Registering index signals
Each time a recording starts, an index signal is automatically registered.
To register it somewhere else, press INDEX f during recording.
Note
A certain interval is required between the index signals: more than 1 minute in
the SP tape speed and more than 3 minutes in the SLP tape speed.
Index search
1
Load a cassette with the index signals registered.
2
Press INDEX in the stop or playback mode.
g
INDEX: To search in the reverse
direction.
f: To search in the forward
INDEX
direction.
The VCR fast-forwards or rewinds the
tape. When an index signal is found, the
VCR plays back the tape for about 5
seconds, and then resumes fast-
forwarding or rewinding. This is repeated
each time at an index signal.
3
Press PLAY/x2 when the desired program is found.
Normal playback starts.
Notes
• At the very beginning of the tape, the index search may not work properly.
• If you registered the index signals on a tape recorded on another VCR, the
recording may be blurred at the index point and the index search may not
work properly.
1
1
Index search
Playback
for 5 sec.
2
Playback
for 5 sec.
0 0 0 0 0
H
M
S
I NDEX MARK
Advertisement
Chapters
Table of Contents
