General Tool Safety Warnings - Chicago Electric 68221 User Manual

Specifications
Electrical Input 120 V~ / 60 Hz / 8.5 A (Rated)
RPM 4200
Spindle
7/8"
Diameter
Cutter Head
28°
Angle (Bevel)
Vise Capacity 0.5" to .8"
Table/Vise
35° Left to Right
Angles
Wheel
1/8" Thick x 4-1/4" Diameter
Dimensions
Save This Manual
Keep this manual for the safety warnings and precautions,
assembly, operating, inspection, maintenance and
cleaning procedures. Write the product's serial
number in the back of the manual near the assembly
diagram (or month and year of purchase if product
has no number). Keep this manual and the receipt
in a safe and dry place for future reference.
Important Safety Information
In this manual, on the labeling, and all other
information provided with this product:
This is the safety alert symbol. It is
used to alert you to potential personal
injury hazards. Obey all safety
messages that follow this symbol to
avoid possible injury or death.
DANGER indicates a hazardous situation which, if
not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if
not avoided, could result in death or serious injury.
CAUTION, used with the safety alert symbol,
indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
Page 2 For technical questions, please call 1-800-444-3353.
NOTICE is used to address practices
not related to personal injury.
CAUTION, without the safety alert symbol, is used
to address practices not related to personal injury.

General Tool Safety Warnings

WARNING Read all safety warnings and
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/
or serious injury.
Save all warnings and instructions
for future reference.
1. KEEP GUARDS IN PLACE and in working order.
2. REMOVE ADJUSTING KEYS AND WRENCHES.
Form habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it on.
3. KEEP WORK AREA CLEAN. Cluttered
areas and benches invite accidents.
4. DON'T USE IN DANGEROUS ENVIRONMENT.
Don't use power tools in damp or wet locations, or
expose them to rain. Keep work area well lighted.
5. KEEP CHILDREN AWAY. All visitors should
be kept safe distance from work area.
6. MAKE WORKSHOP KID PROOF with padlocks,
master switches, or by removing starter keys.
7. DON'T FORCE TOOL. It will do the job better and
safer at the rate for which it was designed.
8. USE RIGHT TOOL. Don't force tool or attachment
to do a job for which it was not designed.
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS
NAMEPLATE
AMPERES
(at full load)
0 – 6
6.1 – 10
10.1 – 12
12.1 – 16
TABLE A
(120 VOLT)
EXTENSION CORD
LENGTH
25' 50' 100'
18 16 16
18 16 14
16 16 14
Do not use.
14 12
150'
14
12
12
SKU 68221