Attaching The Base Plate To The Handlebar Base; Installing Your Device In The Motorcycle Mount; Mounting Your Device In An Automobile; Removing Your Device From The Motorcycle Mount - Garmin Zumo 590 Owner's Manual

the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 40 mm panhead screws
washers , cradle, spacers
2
Tighten the nuts to secure the base plate.

Attaching the Base Plate to the Handlebar Base

1
Align the ball of the handlebar base
base plate with each end of the double-socket arm
2
Insert each ball into the double-socket arm.
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5 Tighten the knob to secure the mount.

Installing Your Device in the Motorcycle Mount

1
Fit the bottom of your device into the cradle.
2
Tilt the device back until it snaps into place.
2
through the
, and base plate .
and the ball of the
.
3 If the latch on top of the mount stays up after you insert the
device, press it down.

Mounting Your Device in an Automobile

Before mounting the device, check the local laws pertaining to
windshield mounting.
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use the suction cup mount on a motorcycle.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
1
Plug the automotive power cable
the mount.
2 Remove the clear plastic from the suction cup.
3
Clean and dry your windshield and the suction cup with a
lint-free cloth.
4
Press the suction cup
back toward the windshield.
5
Snap the cradle onto the suction cup arm.
6
Fit the bottom of your device into the cradle.
7 Tilt the device back until it snaps into place.
8
Plug the other end of the automotive power cable into a
power outlet.
Removing Your Device from the Motorcycle
Mount
1
Press the release button on the side of the mount.
2
Lift out the device.

Support and Updates

Garmin Express™ provides easy access to these services for
Garmin devices. Some services may not be available for your
device.
• Product registration
• Product manuals
• Software updates
• Map, chart, or course updates
• Vehicles, voices, and other extras

Setting Up Garmin Express

1
Connect the device to your computer using a USB cable.
2
Go to www.garmin.com/express.
3
Follow the on-screen instructions.
NOTICE
WARNING
into the connector
to the windshield, and flip the lever
Getting Started
on