Bulletin Hk2003-01; Service Bulletin - Harman Kardon DVD5 Service Manual

DVD5
harman/kardon
Service bulletin # H/K2003-01 Rev1 July 2003
To: All harman/kardon Service Centers
Model: DVD5
Subject: Replacement of Laser Pick-up Assembly
In the event you receive a DVD5 where a Laser Pick-up Assembly replacement is warranted, the
original DVD5 mechanism is no longer available. Follow the instructions below to add a new
replacement mechanism:
I) Order the following parts:
1) Laser Pick-up Ass'y (TVK15-1AA/502T)
2) 10 wire - FCC CABLE
3) 12 wire - FCC CABLE
In addition, if the DVD5 has the early version of the power supply described in h/k bulletin
# HK2002-05, (Figure 3 on page 2), order:
4) 10 wire – CONNECTOR
In addition, if the DVD5 is in the serial number range TH0007-07492 and below, order:
5) 5 Disc Carousel
II) DVD-5 Loader Module Replacement
1) Remove the top cover.
2) Pull all ribbon connectors from the decoder PCB that connect to the chassis.
3) Remove the 4 screws that hold the chassis down to the bottom panel assy.
4) Pull the chassis slightly up in the rear and remove the entire assy. out the back.
h/k part# 10733290RETRO
h/k part# 55174870
h/k part# 55174860
h/k part# 55284430
h/k part# 5502007AMP
Figure 1. New Replacement Loader for DVD-5
34

Service Bulletin

Warranty labor rate: MAJOR repair
harman/kardon
1