THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
and
1
specified.
•
%
: indicates tolerance.
•
: internal component.
¢
• C : panel designation.
Note:
The components identified by
mark ! or dotted line with mark
! are critical for safety.
Replace only with part number
specified.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• AC voltage readings in the bias oscillator with a level
meter.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark : STOP
(
) : PLAY
<
> : REC (CD-R only)
• Voltages are taken with a VOM (Input impedance 10 M ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
5-1. CIRCUIT BOARDS LOCATION
HP board
SECTION 5
DIAGRAMS
/
W or less unless otherwise
4
Les composants identifiés par
une marque
! sont critiques pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro spécifié.
BD-P board
FL board
• Signal path.
J
: CD
c : CD (digital)
I : CD REC
L : CD REC (digital)
• Abbreviation
CND : Canadian model
For printed wiring boards.
Note:
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B)
pattern face are indicated.
Parts face side:
Parts on the parts face side seen from the
(Side A)
parts face are indicated.
• Indication of transistor
C
Q
These are omitted
B
E
• Abbreviation
CND : Canadian model
POWER board
AUDIO board
BD-R board
VOL board
RCD-W3
B
C
E
These are omitted
21