Table of Contents
Advertisement
5. Circuit Adjustment Mode
Except for the following, all adjustment items must be performed
using the remote hand unit.
• Lens Focus
• Electrostatic Focus
A. Activating the Circuit Adjustment Mode
1. Press the "MENU" button on a remote hand unit.
2. Press the number buttons "0", "3", "5", "7" in sequence.
The screen will change to the Adjustment Mode.
Note: Repeat steps 1 and 2 if the circuit
adjustment mode display does not appear
on screen
B. Selection of adjustment Functions and
Adjustment Items
To select an adjustment item in the circuit adjustment mode,
first select the adjustment function that includes the specific
adjustment item to be selected. Then, select the adjustment
item.
Refer to the following pages for the listing of adjustment
functions and adjustment items.
1. Press the "AUDIO" button on a remote hand unit to
select an adjustment function. Each time the button
is pressed, the Function changes in the following
sequence:
Video Chr
HR
2. Press the "VIDEO" button to select a specific
Adjustment Item. The Item number increases each
time the "VIDEO" button is pressed.
C. Changing Data
After selecting an adjustment Item, use the "ADJUST
UP/DOWN" button to change data.
•
Press "ADJUST DOWN" to decrease the data value.
•
Press "ADJUST UP" to increase the data value.
MODEL: WT-42313 / WT-42413
Defl Jung
FUNCTIONS
Sub Matrx
Main Mtrx
Page 18
FUNCTION
Video Chr
Mode 0
MODE
1
SCT
ITEM#
ABBREV.
MENU
ENTER
CHASSIS
K20
NTSC
SIGNAL
55
DATA
ADJUST
UP/DN
VIDEO
AUDIO
Advertisement
Table of Contents
