Mounting On A Wall Or Ceiling - SonicWALL SonicPoint-N Dual-Band Getting Started Manual

Mounting on a Wall or Ceiling

The SonicPoint ships with a mounting plate and E-Z Anchor /
Screw Kit to facilitate simple mounting to most indoor surfaces.
To mount the SonicPoint:
1. Remove the mounting plate from the bottom of the
SonicPoint and place the plate on the location where you
wish to mount the SonicPoint.
2. Using a pencil, mark the location of two of the locking
screw holes. The holes you mark should be directly across
from each other, not adjacent to each other.
3. Screw the larger anchor screws into the wall or ceiling in
the locations you marked until the face of the screw is flush
with the surface.
4. Screw the smaller phillips-head screws into the anchors,
leaving enough space between the screw head and the
anchor surface to fit the mounting plate underneath.
5. Place the mounting plate over the screws and turn to lock.
The plate should fit snugly after turning. Tighten the screws
if needed.
6. Place the SonicPoint onto the mounting plate so the
locking screw lines up with the 'unlock' position.
7. Turn the SonicPoint clockwise until the locking screw lines
up with the 'lock' position on the SonicPoint.
8. Push the mounting screw in and turn clockwise until firm.
Note:
Refer to Product Safety and Regulatory Information
page 44 for further mounting considerations.
-
SonicWALL SonicPoint Getting Started Guide Page 32