Panasonic TH-65PX600U Service Manual page 81

Driver Setup Adjustment
Driver Set-up
Item / Preparation
1. Input a white signal to one of the
unit's video input.
2. Set the picture controls as follows:
Picture menu: Vivid
Picture: +30
Aspect: Full
Caution
1. Perform the Vsus adjustment.
2. Confirm the voltage level of VSCN.
This should be done after the
adjustment of Vad which should be -
105V
Note: The confirmation of Vscn voltage
should be performed after the
adjustment of the Vad voltage.
When Vad = -105V, Vscn voltage is 35V
±4V.
Driver setup adjustment is mandatory after replacing the SC, SS, and P boards. It is
also required after the replacement of the panel. These are some of the
symptoms you may obtain if the adjustment is not performed.
1. Several images may be displayed at the same time
2. Excessive brightness
3. Low brightness
4. Wrong color
5. Reduction of the life span of the panel
The voltage level of VE and VSUS is not listed in the service manual. Refer to the
panel label for the voltage level.
81