Secure Digital(Sd) Board Removal - Toshiba Satellite 5100 Series Replacement Manual

FIELD REPLACEABLE UNIT DOCUMENTATION

SECURE DIGITAL(SD) BOARD REMOVAL

SD support plate
1. Remove one M2x4 brass screw securing the
SD support plate and the sound FIR board.
2. Remove the SD support plate and lift up the back
side of the sound/FIR board to disconnect it from
PJ601 on the system board.
COOLING MODULE REMOVAL
Fan harness
PJ8770
1. Disconnect the fan harness from PJ8770 on the
system board.
2. Remove three M2x8 brass screws and securing the
cooling module to the system board.
3. Peel off the glass tape securing the DC harness and
lift out the cooling module.
Satellite
5100 Series
Sound/FIR
board
M2x4 brass screw
M2x8
brass
screws
Glass tape
Cooling module
TOSHIBA
Tough Enough for Today's World
TM
VIDEO BOARD REMOVAL
Video board
HDD con plate
1. Remove one hex screw securing the HDD con plate
and lift out the plate.
2. Disconnect the video board from system board.
CPU REMOVAL
Close
CPU
lock
CPU
1. Insert a flat head screwdriver in the CPU lock and
rotate it counter-clockwise to unlock the CPU.
2. Lift out the CPU.
NOTE: When installing the CPU, make sure that a silicone
grease is applied before attaching the heat sink.
Please refer to FSB-200112 for the complete
procedures on how to apply the silicone grease.
Hex screw
Open
Silicone grease