Thermostat Installer Setup Options - Honeywell Chronotherm IV T8601D Installation Instructions Manual

T8601D CHRONOTHERM® IV DELUXE PROGRAMMABLE THERMOSTATS
Installer Setup
Number
(Press Time !
Select key to change)
Not used
a
Fan operation
Not used
Heating cycle
rate
Not used 5 thru 11
System setting
adjustment
Adaptive
Intelligent
Recovery™
control
Degree
temperature
display
Not used
Clock format
Not used 17 and 18
Extended fan
operation in
a
heating
Extended fan
operation in
a
cooling
Not used 21 thru 23
Outdoor
temperature
display (select
models)
Not used 25 thru 29
Deadband
Not used 31 and 32
Minimum off
time for the
compressor
69-1410—2
Table 3. Thermostat Installer Setup Options.
Factory-Setting
Display
1 —
2 0 Conventional application
where equipment control
fan operation in heat mode
3 —
4 6 6—6 cph used for
—
12 1 Manual changeover.
13 0 Adaptive Intelligent
Recovery™ control is
activated (system starts
early so setpoint is reached
by start of program period)
14 0 Temperature is displayed
in °F
15 —
16 0 12-hour clock format
—
19 0 No extended fan operation
after the call for heat ends
20 0 No extended fan operation
after the call for cool ends
—
24 0 No outdoor temperature is
displayed
—
30 3 Heating and cooling
setpoints can be set no
closer than 3°F (1.5°C)
—
33 5 5 minute minimum off- time
for the compressor.
Description
—
—
conventional heat.
—
—
—
—
—
—
6
Other Choices
(Press ! or " key to change)
Display Description
— —
1 Heat pump or electric
heat applications where
thermostat controls fan
operation in heat mode
— —
1, 3 or 9 1—1 cph used for radiant
floor heat, gravity
system
3—3 cph used for hot
water systems or high
efficiency furnaces
9—9 cph used for electric
heat systems
— —
0 or 2 0—Auto changeover
2—Auto only
1 Conventional recovery
(system starts recovery at
programmed time)
1 Temperature is displayed
in °C
— —
1 24-hour clock format
— —
1 Fan operation is
extended 90 seconds
after the call for heat
ends
1 Fan operation is
extended 90 seconds
after the call for cool ends
— —
1 Outdoor temperature is
displayed. Needs a
C7089B1000 Outdoor
Sensor to operate
— —
4 thru 10 Heating and cooling
setpoints can be set no
closer that chosen value:
4—4°F (2°C)
5—5°F (2.5°C)
6—6°F (3°C)
7—7°F (3.5°C)
8—8°F (4°C)
9—9°F (4.5°C)
10—10°F (5°C)
— —
0 thru 4 Minimum number of
minutes (0 thru 5) the
compressor is off
between calls for the
compressor
Actual
Setting
—
—
—
—
—
—
—
—