Table of Contents
Advertisement
Nokia Mobile Phones Customer Care E&A
Technical Services, Repair Concepts
Pull up the lower side of the Release Spring and take
it out of the upper holder.
Move up the antenna as shown in the picture. Take
care not to damage the antenna contacts. The metal
is very sensitive against corrosion, so please don't
touch the metal with your fingers. Use gloves
instead.
Remove the protection foil of the display and unlock
the snaps on both sides of the display frame.
The final GoNoGo test verifies that the electrical specifications will be fulfilled.
Service Manual 5210 Level 1
PAGE 11 (19)
Confidential
The Antenna is fixed with four snaps. It is enough, if
you release with tweezers the two snaps at the
battery side.
It is also possible to change the speaker, if needed.
Therefore you have to unscrew these two screws.
Remember to use torque of 8 Ncm when
tightening the speaker screws.
Replace the protection foil. Now you have the
separated plastic frame of the LCD unit. You can now
slightly push out the speaker with your fingers or
tweezers.
Copyright 2002 © Nokia Corporation
Approved 1.0
SQX –00380-en MWy
13.02.2002
Advertisement
Table of Contents
