Self Diagnosis Function - Sony HCD-S888 Service Manual

HCD-S888
General
Power requirements
European model:
Other models:
Power consumption
Power requirements (Subwoofer)
European model:
Other models:
Power consumption (Subwoofer) 90 W (1 W in standby mode)
Dimensions (approx.)
Mass (approx.)
Operating temperature
Operating humidity
Design and specifications are subject to change without notice.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
This appliance is classified as a
CLASS 1 LASER product. The label
is located on the bottom exterior.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED
LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS
AND IN THE PARTS LIST ARE CRITICAL TO SAFE
OPERATION. REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
LISHED BY SONY.
2
220 – 240 V AC, 50/60 Hz
110 – 240 V/220 – 240 V AC, 50/60 Hz
120 W (120 V AC) 120 W (230 V AC)
1 W (120 V AC) 2 W (230 V AC)
(at the Power Saving Mode)
220 – 230 V AC, 50/60 Hz
220 – 240 V AC, 50/60 Hz
355 × 60 × 323 mm
(14 × 2 × 12
3 / 3 / inches)
8 4
(w/h/d) incl. projectingparts
3.8 kg (8 lb 7 oz)
5˚C to 35˚C (41˚F to 95˚F)
5 % to 90 %

SELF DIAGNOSIS FUNCTION

Self-diagnosis Function
(When letters/numbers appear in the
display)
When the self-diagnosis function is
activated to prevent the system from
malfunctioning. In this case a five-character
service number (e.g., C 13 00) with a
combination of a letter and digits appears on
the screen and the front panel display. Refer
to the following table.
C:13:00
First three Cause and/or Corrective
characters of
Action
the service
number
C 13
The disc is dirty.
, Clean the disc with a soft
cloth.
C 31
The disc is not inserted
correctly.
, Re-insert the disc
correctly.
E XX To prevent a malfunction, the
(xx is a number) system has performed the self-
diagnosis function.
, Contact your nearest Sony
dealer or local authorized
Sony service facility and
give the 5-character
service number.
Example: E 61 10
Note: Refer to the "5. TEST MODE" (page 19) for another self-diagnosis
function.