Safety Information - Epson Aculaser C4000 Setup Manual

C. If the printer does not operate normally or exhibits a
distinct change in performance.
D. If the printer has been dropped or the cabinet damaged.
E. When the power cord or plug is damaged or frayed.
If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and
over-current protection for this printer, the building
installation must be protected by 10 or 16 ampere circuit
breaker.

Safety Information

Power cord
c
Caution:
Be sure the AC power cord meets the relevant local safety
standards.
Laser safety labels
w
Warning:
The use of controls, or the performance of procedures and
adjustments other than those specified in this guide may result in
hazardous radiation exposure.
4
Safety Instructions
Your printer is a Class 1 laser product
as defined in the IEC60825
specifications. The label shown below
is attached in countries where
required.