Appendix; Care; Contact With Liquid; Questions And Answers - Gigaset C28H User Manual

Appendix

Appendix

Care

Wipe the base station and handset with a
damp cloth (do not use solvents) or an anti-
static cloth.
Never use a dry cloth. This can cause static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Immediately switch the handset off
and remove the batteries.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset,
with the battery compartment open and
the keypad facing down, in a dry, warm
place for at least 72 hours (not in a mi-
crowave oven, convection oven, or simi-
lar place).
4. Do not switch on the handset again un-
til it has completely dried.
When it has fully dried, you should be able to
use it again normally.

Questions and answers

If you have any questions about the use of
your telephone, you can contact us at any
time atwww.gigaset.com/service
The troubleshooting section (page 14) con-
tains a list of common problems and possi-
ble solutions.
Troubleshooting
The display is blank.
1. The handset is not switched on. ¥
a
Press and hold the End Call key.
¥
2. The batteries are empty.
Charge or replace the batteries (page 6).
14
The handset does not respond to a key press.
¥
The keypad lock is activated.
Base Search and
screen.
1. The handset is outside the range of the base
2. The handset has been de-registered. Please
!
3. The base station is not switched on.
Handset does not ring.
¥
The ring tone is switched off.
The other party cannot hear you.
j
You have pressed the display key
¥
Press and hold the pound key
Ä
is flashing on the display
station. ¥
Reduce the distance between handset/
base station.
Register is flashing on the display screen. ¥
Register the handset (page 12).
¥
Check the base station power cord
(page 6).
Activate the ring tone (page 13).
key. The handset is on hold.
Press the left display key to switch on the
microphone again.
#
(page 1).
§Mute§
or the