Installation Stacking - Samsung DV9 Series User Manual

INSTALLATION STACKING

In case of purchasing the additional stacking kit, contact our Samsung service center or local
distributers. [Part no. SK-DH / SK-DA / SKK-DF]
The stacking kit diff ers depending on the model.
Only use the product in 1 hour after installing the stacking kit by tilting the product so that the product
can run after the oil in the compressor becomes stable.
1. Carefully lay the dryer on its side. Use the packing material so
you don't scratch the fi nish on the dryer.
2. Install rubber pads to dryer base.
• Locate the 4 rubber pads in the parts package. Insert the
• Purchase the stacking-kit package additionally.
3. Set the dryer upright.
The stacking kit can only be installed for Samsung family products.
CAUTION
4. Install bracket to dryer.
• Remove washer top cap screw from the rear left. Align left
• Repeat the above step with the right side.
5. Install dryer and bracket on washer
• Lift the dryer on top of the washer. Protect the washer
WARNING
• Align the holes in the bracket with the holes in the back of
• Tighten the washer bracket screws ; then tighten all stacking kit screws.
6. Finalise the installation
• Refer to the washer Installation Instructions to complete
WARNING
• Refer to the dryer Installation Instructions to complete the
• Carefully slide or walk the stacked washer and dryer
DV90F5E6HGW-03297A-02_EN(UK)_130826.indd Sec3:15 DV90F5E6HGW-03297A-02_EN(UK)_130826.indd Sec3:15
rubber pads into the holes at the bottom of the levelling legs.
bracket holes with top cap screw hole on rear left of the unit
and replace screw.
Leave screw loose so dryer hole alignment will be easier.
control panel with cardboard or other protection. Be sure to
lift the dryer high enough to clear the washer control panel.
Personal Injury. More than two people are recommended
to lift the dryer into position because of its weight and size.
Failure to do so could result in injury.
the dryer.Using a Phillips screwdriver, attach the M4x12 tapping screws.
the washer installation.
dryer installation.
into place. Use felt pads or other sliding device to assist
moving and to protect fl ooring.
Do not push on the dryer once installed to top of the
washer. Pushing on the dryer may result in pinched fi ngers.
Bracket-Stacking
Screw
Dryer
Washer
installing your dryer _15
2013-08-28 2013-08-28 11:35:34 11:35:34