Table of Contents
Advertisement
<< SETUP MENU >>
GENERAL SETTING
AE MODE
WB MODE
NIGHTSHOT MODE
BLC/WDR MODE
PZM SETTING
CAMERA ID SETTING
SPECIAL FUNCTION
FACTORY DEFAULT
EXIT MENU
<<GENERAL SETTING>>
0
SYNC. LEVEL
98
BURST LEVEL
AUTO
SYNC. MODE
L/L
RETURN
<Fig5-2. SETUP MENU change>
<<GENERAL SETTING >>
① SYNC. LEVEL
0
② BURST LEVEL
98
③ SYNC. MODE
L/L
④ V. PHASE
000
RETURN
<Fig5-3. General Setting >
5.2 Display SETUPMENU
a. Press and hold the MENU (center) button for 2 seconds to display the Setup
menu.
b. Press the UP or DOWN buttons to select a menu item.
5.3 Move from SETUPMENU to submenu
a. Press the MENU button to enter the selected submenu.
b. Press the + or – buttons to increase/decrease the value of the selected item.
5.4 Saving your Settings
When you are satisfied with your settings:
a. Press MENU for two seconds. The submenu is replaced by one of two messages:
① "QUIT?" : displays when you have not changed any settings.
Selecting QUIT exits OSD menu without saving any changed values.
② "SAVE?" : displays when values have been changed.
Selecting SAVE exits OSD menu and saves your changes.
b. Press + or – to select SAVE or QUIT and press MENU to exit OSD. Press UP or
DOWN buttons to cancel the SAVE/QUIT and return to the OSD.
5.5 General Setting
① SYNC. Level
: Adjust the proper SYNC. Level from 0~15.
SYNC. LEVEL
② BURST Level
: Adjust the proper BURST Level from 0~255.
BURST LEVEL
③ SYNC. Mode
: To synchronize the vertical interval sync pulse of your camera with other
equipment to reduce the effect of picture roll on the monitor.
SYNC. MODE
④ Vertical Phase
: Adjust the proper phase in L/L.
V. PHASE 0 → 1 → ... → 524
Notice
☞
L/L mode is not available in DC 12V power.
- 12 -
0 → 1 → ... → 15
0 → 1 → ... → 255
AUTO → INTERNAL → L/L
Advertisement
Table of Contents
