Set Up Address Reservation - NETGEAR JNR1010v2 N150 User Manual

• Subnet mask
• Gateway IP address (the router's LAN IP address)
• DNS server IP address (the router's LAN IP address)
You can use another device on your network as the DHCP server or you can manually
configure the network settings of all of your computers and devices.
To disable the DHCP server feature:

1. Log in to the router.
For more information, see
2. Select ADVANCED > Setup > LAN Setup.
The LAN Setup screen displays.
3. Clear the Use Router as DHCP Server check box.
4. Click the Apply button.
If the DHCP service is not enabled on the router and no other DHCP server is available on
your network, you must set your computers' IP addresses manually or your computers are
not able to access the router.

Set Up Address Reservation

When you specify a reserved IP address for a computer or device on the LAN, that computer
or device always receives the same IP address each time it accesses the router's DHCP
server. Reserved IP addresses should be assigned to computers or servers that require
permanent IP settings.
To reserve an IP address:

1. Log in to the router.
For more information, see
2. Select ADVANCED > Setup > LAN Setup.
The LAN Setup screen displays.
3. In the Address Reservation section of the screen, click the Add button.
JNR1010v2 N150 Wireless Router
Log In to Your Router After Installation
Log In to Your Router After Installation
genie ADVANCED Home
49
on page 18.
on page 18.