Replacing The Linear Imager Scanner Battery - Motorola LI4278 Product Reference Manual

Replacing the Linear Imager Scanner Battery

The battery is installed in the cordless linear imager scanner by the factory and resides in a chamber in the
linear imager scanner handle. To replace the battery:
Insert a Phillips screwdriver in the screw at the base of the linear imager scanner, then turn the screw
1.
counterclockwise to release the latch.
Remove the latch.
2.
If a battery is already installed, turn the linear imager scanner upright to slide the battery out. Disconnect
3.
the battery connector clip.
1 1
Battery Connector
4
Inserting the Battery
Figure 1-9
With the contacts on the connector clips facing in the same direction, attach the new battery's connector
4.
clip to the connector clip in the base of the linear imager scanner.
Slide the new battery into the battery well and ensure the battery leads are visible. The battery should sit
5.
securely in the well.
Attach and close the latch.
6.
Insert a Phillips screwdriver in the screw at the base of the linear imager scanner, press down gently, and
7.
turn the screw clockwise to lock the latch in place.
2
Clip
5
GETTING STARTED 1 - 11
3
6