Table of Contents
Advertisement
Always have the power turned OFF prior to connecting or
disconnecting the IR detector or emitter module.
The IR emitter should be located or attached so that it will operate the source equipment.
Connect the IR detector module (not included) to each receiver unit as needed.
The IR detector module should be located such that it has an unobstructed view of the room where the
remote will be used. Best results are obtained if the IR detector is located away from interfering sources
such as florescent lamps, or shielded from being directly illuminated by them.
Note: IR detectors from Xantech and others are not compatible with the DAVES
attempt to connect an unapproved IR detector to the system, as permanent damage to the equipment may
occur.
The DAVES Matrix unit is configured to accept standard audio/video signals from a wide variety of
sources, such as DVD players, Laser disk players, DSS receivers, CD players, VCRs, and other
equipment.
The stereo audio inputs accept standard "line level" audio levels.
The video input accepts standard 1 volt
Do not connect any audio / video source that does not conform
Do not exceed 3 V
RMS
signal levels. These should be attenuated or severe audio distortion may occur.
The receiver unit is configured to output standard "line level" audio levels at the stereo audio outputs, and
standard 1-volt p-p video levels at the video output.
IR
/ Emitter
Detector
(Optional)
Important!
Audio / Video connections
p-p
video levels.
Important!
to standard "line level" signals!
into the "line level" audio inputs. Some high-end equipment may have higher
OWI Incorporated
17141 Kingsview Ave. Carson CA 90746
Tel. 310-515-1900
www.owi-inc.com
Installation
TM
system. Do not
9
Advertisement
Table of Contents
