24-Hour Digital Timer; Maintenance - DeLonghi DCH5090EL Instructions For Use Manual

6. Eco function
In this operating mode the appliance will
automatically set the power level to gua-
rantee the best comfort reducing the
energy consumption. In this operating
mode the unit may switch the heating
power level from maximum to minimum
and viceversa, several times in an hour.
When using the ECO function, the maxi-
mum temperature setting is 79°F (26°C).
To activate this function, press the ECO
button (D). The unit, will always start at
the maximum power.
7. If you want the appliance to distribute the
airflow over a larger area, press the oscil-
lation button (C) (
then oscillate right and left. To stop the
oscillation in the desired position, just
press oscillation button (C) again.
8. To turn off the appliance press button
ON/OFF (A). The display will show a count
down for about 6 seconds.
NOTE: The display can show the temperature
in both °F and °C. To change the temperature
scale, press and hold the + key for few
seconds, then release.

24-HOUR DIGITAL TIMER

This function can be activated from any opera-
ting mode.
Delayed switch-on: with the appliance in the
OFF position, press the timer button (E) (
The display shows the symbol
time remaining before switch-on. To set the
timer, use the + and - adjustment buttons
(B), then wait a few seconds for the pro-
gramming to be set.
The display returns to show "
by and the symbol
set the timer. When the programmed time
has been reached, the appliance turns on
with the same settings it had during the pre-
vious operation.
Delayed shut-off: With the appliance on, press
the timer button (E) (
shows the symbol
ning before shut-off. To set the timer, use
the + and - adjustment buttons (B), then
wait a few seconds for the programming to
be set. The display returns to show the cur-
rent settings and the symbol
you have set the timer. When the program-
med time as been reached the appliance
). The appliance will
).
and the
" for stand-
G
to indicate you have
). The display
and the time remai-
to indicate
shuts off automatically.
If you want to go back to operation without the
timer, press the timer button (F) twice.
The timer symbol
display.

MAINTENANCE

- Before carrying out any maintenance,
always remove the plug from the power
outlet.
- During the season when the appliance is
being used, regularly clean the air intake
and outlet grilles using a vacuum clea-
ner.
- Never use abrasive powders or solvents to
clean the appliance.
WARNINGS
- Never use this heating appliance in the
immediate vicinity of a bathtub, shower, or
swimming pool.
- Use the appliance always and only in the
vertical position.
- Do not use the appliance to dry laundry,
and do not obstruct the air intake and
outlet grilles (danger of overheating).
- Do not operate the appliance in contact
with walls, furniture, curtains, etc.
- If the power cord is damaged, it must be
replaced by the manufacturer, the authori-
zed service facility, or a qualified electri-
cian, in order to prevent the risk of mal-
function.
- Do not cover the appliance while it is ope-
rating, as this could potentially cause a
fire.
- Do not use this appliance in a room smal-
ler than 43 square feet (4 m²).
- Heaters should never be used with an
extension cord or outlet strip. Heaters
should be plugged directly into an outlet.
- Before storing the appliance, check it is
completely off and the cable is unplugged.
At this point wrap the cord around the base.
Do not store in a dusty room. The room
temperature should be between 32-86°F (0-
30°C). Do not load anything above it.
- Heaters draw more current than small
appliances, overheating of the outlet may
occur even if it has not occured with the
use of other appliances.
Meijer.com
disappears from the
5