Honda 2000 Civic Coupe Owner's Manual page 208

Main Menu
Table of Contents
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
5. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked "TOP."
7. Push the electrical connector onto
the tabs of the new bulb. Make
sure it locks in place.
Turn on the headlights to test the
new bulb.
8. (Driver's side)
Reinstall the power steering
reservoir.
Replacing the Front Side Marker/
Turn Signal and Parking Light
Bulb
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger' s side, turn
the steering wheel to the left.
HOLDING
CLIP
2. Use a flat-tipped screwdriver to
remove the holding clip from the
inner fender.
3. Pull the inner fender cover back.
4. Remove the socket from the
headlight assembl y by turning it
one-quarter turn counterclockwise .
Lights
CONTINUED
Maintenance