Honda 2009 Accord Coupe Owner's Manual page 259

GRIP SUPPORT ROD
CLIP
2.4 engine models
3. 2.4 engine models
Holding the grip, pull the support
rod out of its clip. Insert the end
into the hole in the hood
designated by an arrow.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
Service Station Procedures
V6 models
V6 models
Lift the hood up most of the way.
The hydraulic supports will lift it
up the rest of the way and hold it
up.
To close the hood, lower it to
about a foot (30 cm) above the
fender, then press down firmly
with your hands. Make sure the
hood is securely latched.
253