Hunter 99127 User Manual

Installation
OFF
Before installing the
Remove the canopy. If uncertain
Universal Remote Control
how to remove it, reference the fan's
Receiver, use the pull chains
owner's manual. With wiring exposed,
to set the fan speed to HIGH
it may be helpful to note existing wire
and the light to ON. Be
connections or take a digital photo for
sure power is OFF before reference. Remove the wire connectors
proceeding with installation. that connect the wires from the outlet
box to the fan, leaving the grounding
wires connected.
Wiring
blue
yellow
CONNECT WIRES FROM RECEIVER TO FAN - Using the orange wire connectors, connect the blue wire from the
receiver to the blue wire (or possibly black with white stripe wire) from the fan. Connect the yellow wire from the
receiver to the black wire from the fan.
If you're uncertain about wire colors or connections, please contact a qualified electrician.
To avoid possible electrical shock, before installing or servicing your fan, disconnect
the power by turning off the circuit breakers to the outlet box and associated wall
switch location. If you cannot lock the circuit breakers in the off position, securely
fasten a prominent warning device, such as a tag, to the service panel.
Universal 3 Speed
Ceiling Fan Remote
Model 99127
Receiver
OR
Canopy
Choose the hanging system that most closely resembles the one used by your fan and install the receiver as shown and wire as directed.
Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8" remaining. Re-strip the fan lead wires 1/2" . Place remaining excess
wire into the ceiling electrical box. The bracket and fan must remain properly grounded.
You may have installation issues if the fan is installed on an angled ceiling. For assistance, call 1-866-268-1936.
blue
black
M0077-01 • 01/14/14 • © Hunter Fan Company
If you are installing multiple remote-controlled fans
on the same circuit breaker,
you may need to perform a few extra steps to prevent
interference or faulty operation of your remote controls.
Go to www.HunterFan.com/FAQs and click "How do I properly
install multiple remote-controlled fans?" for more information.
Ceiling
Plate
Receiver
OR
Receiver
Canopy
Canopy
black black (ungrounded)
white
white white (grounded)
CONNECT WIRES FROM RECEIVER AND FAN TO WIRES FROM OUTLET BOX - Using the orange wire connectors,
connect the black wire (ungrounded) from the ceiling to the black wire from the receiver. Connect the white wire
(grounded) from the ceiling to both the white wire from the receiver and the white wire from the fan.
AFTER ALL WIRES ARE CONNECTED and secured with wire connectors, re-install the canopy.
Turn the splices upward and push them carefully back through the hanger bracket
into the outlet box. Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the outlet box.
www.HunterFan.com
1.866.268.1936
For low pro le fans, the receiver should
be secured to the ceiling bracket with a
cable tie.
Cable Tie
Ceiling
Bracket
OR
Receiver
Fan Body