Installing The Network Connector; Removing The Coin-Cell Battery - Dell Latitude E6540 Owner's Manual

Installing the Network Connector

1. Align the network connector to its position on the computer.
2. Place the network-connector bracket on the network connector.
3. Tighten the screw to secure the network-connector bracket to the computer.
4. Route the cable through the routing channel.
5. Connect the cable to the system board.
6. Install:
a) base corner cap (left)
b) base cover
c) battery
7. Follow the procedures in

Removing the Coin-Cell Battery

1. Follow the procedures in
2. Remove:
a) battery
b) base cover
3. Disconnect the coin-cell battery cable, pry the coin-cell battery upward and remove it from the computer.
24
After Working Inside Your Computer .
Before Working Inside Your Computer .