Replacing The Status-Light Board; Procedure; Postrequisites - Dell Alienware 14 Owner's Manual

Replacing the Status-Light Board

WARNING:
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. After working inside your computer,
follow the instructions in "After Working Inside Your Computer" on
page 11. For additional safety best practices information, see
the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.

Procedure

1 Slide the status-light board under the tab on the palm-rest assembly and align the
screw hole on the status-light board with the screw hole on the palm-rest assembly.
2 Replace the screw that secures the status-light board to the palm-rest assembly.
3 Slide the status-light board and power-button board cables into the status-light
board connectors and press down on the connector latches to secure the cables.
4 Connect the speakers cable to the status-light board connector.

Postrequisites

1 Follow the instructions from step 5 to step 10 in "Replacing the Palm Rest" on
page 36.
2 Follow the instructions from step 8 to step 10 in "Replacing the Secondary Hard-Drive
(optional)" on page 22.
3 Replace the battery. See "Replacing the Battery" on page 15.
4 Replace the base cover. See "Replacing the Base Cover" on page 13.
5 Follow the instructions in "After Working Inside Your Computer" on page 11.
42
| Replacing the Status-Light Board
Before working inside your computer, read the safety