Dell PowerEdge C8220X Hardware Owner's Manual page 330

4 Connect the following cables to the system board.
– I2C cable. See Figure 3-126.
– System board control cable. See Figure 3-125.
– SATA cable. See Figure 3-124.
– Power cable. See Figure 3-123.
5 You must route the cables properly on the sled tray to prevent them from
being pinched or crimped.
6 Install the node power distribution board. See "Installing the Node Power
Distribution Board" on page 317.
7 If applicable, install the BMC management cable. See "Installing the BMC
Management Cable" on page 314.
8 Install the interposer extender to the new board. See "Installing the
Interposer Extender" on page 312.
9 Install the hard-drive tray. See "Removing the Hard-Drive Tray" on
page 172.
10 Install the internal hard-drives. See "Installing a Hard-Drive Carrier on the
Sled Tray" on page 170.
11 Install the MicroSD card reader support bracket. See "Installing the
MicroSD Card Reader Support Bracket" on page 310.
12 Install the MicroSD card reader. See "Installing the MicroSD Card Reader"
on page 308.
13 Transfer the processors to the new system board. See "Removing a
Processor" on page 283 and "Installing a Processor" on page 285.
14 Remove the memory modules and transfer them to the same locations on
the new board. See "Removing Memory Modules" on page 289 and
"Installing Memory Modules" on page 290.
15 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 277.
16 If applicable, install the mezzanine card. See "Installing the SAS
Mezzanine Card" on page 297, "Installing the Infiniband Mezzanine Card"
on page 301, or "Installing the 10 GbE Mezzanine Card" on page 304.
330
Installing System Components