American DJ LS-70 User Instruction

LS-70
Portable Lighting System
LS-70 Parts List:
• 4 x Par 38 Polished Par Cans
• 4 x Medium Screw Base LED Bulbs rated at 100,000 hr. life
(1 x Red, 1 x Yellow, 1 x Green, 1 x Blue)
• 1 x T20F Chase Controller
• 1 x LTS-6™ Light Stand which includes:
1 x Tripod stand
1 x T-bar
2 x collars
2 x telescoping posts
4 x adjustment knobs
4 x bolts and wing nuts
Instructions for setting up your LTS-6™ Light Stand: (See reverse side for a set up diagram)
1. Set up the Tripod stand by adjusting the width of its legs. When the desired width has been se-
lected, tighten the knob on the base of the Tripod.
2. Adjust the telescopic center posts by loosening the knobs on the collars to the preferred height.
The posts will slide into one another going from the largest at the bottom to the smallest at the
top. Tighten the knobs in the collars.
3. Fasten the four bolts and four wing nuts into the T-bar. Finish by placing the T-bar connection
into the top-most center post. It will only fit in the smallest post. Tighten the knob on the collar.
4. Reposition if needed, recheck all knobs, and tighten all fastners before mounting any fixtures to
your completed LTS-6 light stand.
Buttons and Switches:
1. Blackout Selector - The function of stand-by can be approved or forbidden by Blackout Selector.
2. Linkup Selector - Use this switch to select master or slave is a master/slave configuration.
3. Function Selector - This is used to select Audio/Fast/Medium/Slow mode for the patterns.
4. Channel LED - These LEDS indicate the intensity of the corresponding channel or activity of the
pattern or scene.
5. Stand By Button: This button has differnet functions. In Master mode, tap this button to activate
or deactivate Stand By (its LED flashes when Stand By is active). Press this button for three seconds
to activate one of 15 chase modes or 9 fixed scenes. When chase patterns are activated, each tap of
Pattern button will select a chase pattern. When the scenes are activated, each tap of Pattern button
will forward a scene step by step.
6. Pattern Button: In Master mode, use this button to select chase pattern or scene.
©American DJ ® Los Angeles, CA 990040 USA