Connecting To A Network - Yamaha RX-S600 Owner's Manual

1 2 3 4 5 6 7 8 9 10
6

Connecting to a network

Connect the unit to your router with a commercially-available STP network cable (CAT-5
or higher straight cable).
You can enjoy Internet radio or music files stored on media servers, such as PCs and
Network Attached Storage (NAS), on the unit.
Internet
WAN
LAN
Modem
Router
Network cable
HDMI 5
HDMI ARC (BD/DVD) HDMI 1 HDMI 2 HDMI 3 HDMI 4 MHL 5V 1A
OUT
ANTENNA
AV 4 AV 5 DC OUT
(RADIO)
5V 0.5A
AM FM
OPTICAL CONPONENT Y P B P R
VIDEO
VIDEO
AV 1
75
AUDIO 2 AUDIO OUT
VIDEO
COAXIAL
AV 2 SUBWOOFER
PRE OUT
COMPONENT
VIDEO MONITOR
OUT
COAXIAL AUDIO 1
AV 3
(TV)
VIDEO
Y P B P R
• If you are using a router that supports DHCP, you do not need to configure any network settings for the unit,
as the network parameters (such as the IP address) will be assigned automatically to it. You only need to
configure the network settings if your router does not support DHCP or if you want to configure the network
parameters manually (p.90).
• You can check whether the network parameters (such as IP address) are properly assigned to the unit in
"Information" (p.90) in the "Setup" menu.
Network Attached Storage
(NAS)
PC
NETWORK
(NET)
SPEAKERS
EXTRA
FRONT CENTER
SURROUND
/BI-A
The unit (rear)
• Some security software installed on your PC or the firewall settings of network devices (such as a router)
may block the access of the unit to the network devices or the Internet. In these cases, configure the
security software or firewall settings appropriately.
• Each server must be connected to the same subnet as the unit.
• To use the service via the Internet, broadband connection is strongly recommended.
PREPARATIONS ➤ Connecting to a network
29
En