Blade Removal And Installation - Honda Harmony II HRT216PDA Owner's Manual

BLADE REMOVAL AND INSTALLATION

If you remove the blade(s), use a torque wrench for installation.
Wear heavy gloves to protect your hands. To avoid weakening the
blade(s), or causing imbalance or poor cutting, the blade(s) should
be sharpened by trained staff at an authorized Honda servicing
dealer. If replacing the blade, use a genuine Honda replacement
blade(s) or equivalent.
1. Removal: Turn the fuel valve to OFF. Disconnect the spark plug
cap, then tilt the mower to the right side (carburetor side up).
2. Remove the two blade bolts with a 14 mm socket. Use a wooden
block to prevent the blade(s) from turning when removing the bolts.
Remove the blade(s) from the blade holder.
3. Installation: Clean around the blade holder. Install the blade(s)
using the bolts and special washers as shown (concave side of the
special washers toward the blade(s)).
The blade bolts and washers are specially designed for the mower.
Should you ever have to replace them, use only genuine Honda
parts. Otherwise, a blade may become detached from the mower
and cause serious injury.
4. Tighten the bolts with a torque wrench. Use a wooden block to stop
the blade(s) from turning.
Blade bolt torque: 36 ~ 43 ft-lb (49 ~ 59 N m)
BLADE HOLDER
UPPER
BLADE
( HRT)
LOWER
BLADE
SPECIAL
WASHER (2)
BLADE BOLT (2)
MAINTENANCE
39