Weil-McLain CGa User's Information Manual page 20

CGa, CGi, CGs, EG, EGH, LGB, PEG, PFG Boilers
Operating instructions
• Spark-ignited pilot
• Gas valve — Robertshaw 7000DERHC
FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance is equipped with an ignition device
which automatically lights the pilot.
to light the pilot by hand.
B. BEFORE OPERATING
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor. See below.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
1. STOP! Read the safety information above on this label.
2. Set the thermostat to lowest setting.
3. When equipped with Effikal vent damper Model RVGP, place service switch in Hold
Damper Open position.
4. Turn off all electrical power to the appliance.
5. Remove front panel.
6. When equipped with Johnson Controls vent damper Model M35, manually rotate
damper blade indirection of arrow to
7. Turn gas control knob clockwise
8. When equipped with vent damper, verify damper blade is in full open position.
9. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.
If you smell gas, STOP!
gas, go to the next step.
10. Turn gas control knob counterclockwise
11. Turn on all electric power to the appliance.
12. When equipped with Effikal vent damper, place service switch in Automatic Operation
position.
13. Set thermostat to desired setting.
14. If the appliance will not operate, follow the instructions
APPLIAnCE "
below and call your service technician or gas supplier.
15. Replace front panel.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
20
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
C. Use only your hand to turn the gas control knob. Never use tools. If
Do not try
, smell all around the
D. Do not use this appliance if any part has been under water.
WHAT TO DO IF YOU SMELL GAS
OPERATING INSTRUCTIONS
"OPEN" position indicated on damper assembly.
"OFF" .
to
Follow "B" in the safety information above. If you don't smell
"ON"
to
TO TURN OFF GAS TO THE APPLIANCE
EGH-85 to EGH-125,
PFG-6 to PFG-8
the selector arm will not depress or move by hand, don't try to repair
it, call a qualified service technician. Force or attempted repair may
result in a fire or explosion.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control,
which has been under water.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
.
TO TURn OFF GAS TO
"
3. Remove front panel.
4. Turn gas control knob clockwise
5. Replace front panel.
to "OFF" .
550-223-045(1101)
Part Number 550-110-592/0709