Disk Drive Removal; Model And Parts Numbers - Fujitsu MPC3032AT Maintenance Manual

Model
MPC3032AT
MPC3043AT
MPC3064AT
MPC3084AT
MPC3096AT
MPC3102AT
2.2

Disk Drive Removal

The method and procedures to dismount the disk drive to check the jumper terminal, change
the jumper position, or replace the device differ depend on the system cabinet structure.
Therefore, for actual working procedures, the specific conditions necessary for each system
must be determined. The general removal procedures, with notes, is as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the system cabinet.
c) When storing or transporting the drive, pack it an antistatic bag.
Note:
To protect the device from damage and prevent the worker getting hurt, observe the parts
in Subsection 1.1.1 on Danger and Warnings.
1. Perform any removal after the system power is completely
disconnected.
screws that attach the drive must not be removed with the power
ON.
2. Do not move the drive until it comes to a complete stop (about
30 seconds after the power is turned OFF).
3. Perform the human body grounding to discharge any static
electricity from your body.
2 - 2
Table 2.1

Model and parts numbers

Part Number Formatted
capacity
CA01675-B321 3243.66 MB
CA01675-B331 4325.52 MB
CA01675-B341 6488.29 MB
CA01675-B561 8455.20 MB
CA01675-B361 9747.58 MB
CA01675-B661 10242.74 MB
The cable must not be disconnected and the
C141-F029-02EN
Mounting Screw
No. 6-32UNC