OPERATION
6 mm CAP NUTS
6 mm FLANGE
BOLTS
FLYWHEEL COVER
2.
Remove the two 6 mm cap nuts
and 6 mm flange bolts, and
remove the flywheel cover.
28
3.
Set the controls the same as for
normal starting (see pages
26
). Use the choke control if
needed.
4.
Set the knotted end of the
emergency starter rope in the notch
in the flywheel. Wind the rope
clockwise around the flywheel.
−
25
5.
Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling the rope.
If necessary, rewind the rope and
pull again. If the engine does not
start after several attempts, refer to
TAKING CARE OF
UNEXPECTED PROBLEMS,
p.
63
.
STARTER ROPE