Using The Wired Remote - Cambridge SoundWorks MegaWorks THX 2.1 250D User Manual

MWorks250-CLE.book Page 7 Monday, September 16, 2002 10:11 AM

Using the Wired Remote

To turn the system On/Off To turn the system On/Off
Turning the system On/Off
Varying/muting the volume
❒ Ensure that the subwoofer's ❒
If the Master Volume Mode
main power switch is On.
Indicator is lit, press
❒ Press the Standby/Power
to vary the system volume.
❒
Button once. The red indicator If the Master Volume Mode
Indicator is not lit, press the
above the button shuts off. The
Mode Select Button until the
Master Volume Mode
Master Volume Mode Indicator
Indicator lights up.
❒ To switch the system to is lit. Then press
❒
To increase the rate of
Standby Mode, press the
adjustment, hold down
Standby/ Power Button again.
Notes
Notes
• The remote will revert to Master
• On first power-on, the system uses
Volume Mode if left idle for some
a preset default master volume
time.
level: two volume Level
Indicators will be lit. • To mute the master volume, press
• On subsequent power-on, the the Mute Button once. The
system volume will be muted. All
system reinstates the last-used
previously-lit Level Indicators
master volume level.
will blink during the muting.
• All volume and Sub/Treble set-
• To return to listening, press the
tings will be lost if you turn off the
main power switch, or remove the Mute Button again. Or press
AC power cord or wired remote, or or
• For your own safety, reduce the
if there is a power interruption. The
master volume level before switch-
system will revert to default master
ing the system to Standby Mode.
volume and Sub/Treble levels.
Adjusting Sub/Treble levels
❒ Press the Mode Select Button
until the Sub or Treble Mode
or
Indicator is lit.
❒ To increase or reduce the Sub/
Treble level, press
❒ To increase the rate of adjust-
ment, hold down
or .
or .
Notes
• On first power-on, default Sub/
Treble levels (flat response) are
applied. Three Level Indicators
will be lit to reflect this. Pressing
boosts the level, and causes
more Level Indicators to be lit.
Pressing
causes fewer Level Indicators to
be lit.
• Subsequent Sub/Treble settings
to return to normal listening.
will be stored during Standby
Mode, and recalled when you next
turn the system on using the remote.
Using Headphones
❒ For private listening, you can
connect headphones to the
Headphones Output of the
wired remote. This will mute
all speakers.
or .
❒ Adjust the headphones volume
as you would for the speakers.
or .
❒ The Sub Mode can be used to
adjust the bass level you hear
from the headphones.
Notes
• Treble settings can be adjusted in
the same way as for the speakers.
• When you disconnect the
headphones, the system will revert
to a preset default master volume
setting (two Level Indicators lit),
in order to prevent high
reduces the level, and
headphones volume levels from
being applied to the system
speakers.
Fig 1: Wired
remote
7