Advertisement
MWorks THX 650D CLE.book Page 2 Wednesday, January 8, 2003 10:03 AM
Using the Wired
Remote Control
Level
Indicators
Headphones Output
Figure 1:
Remote Control
2
Turning the speaker system On/Off
Ensure that the subwoofer's
❒
main power switch is turned on.
To turn on the speaker system or
❒
switch to power-on mode, press
the STANDBY/ POWER button
once. The red indicator above the
button shuts off, and the
MASTER volume mode
indicator lights up.
To turn off the speaker system or
❒
switch to standby mode, press
the STANDBY/ POWER button
again. The red indicator above
the button lights up.
Notes
• On first power-on, the speaker system uses
default volume, subwoofer and treble
settings.
• On the subsequent power-on, the system
reinstates the last-used volume, subwoofer
and treble settings.
• Volume, subwoofer and treble settings will
revert to the default if you turn off the
main power switch, disconnect the AC
power cord or remote control, or if there is
a power interruption.
Adjusting Front/Center/Rear volume
To adjust the volume of all
❒
speakers, press the SELECT
button until the MASTER
volume mode indicator is lit.
❒
To adjust the volume of the
center speaker, press the
SELECT button until the
CENTER mode indicator is lit.
To adjust the volume of the rear
❒
speakers and rear center speaker,
press the SELECT button until
the REAR mode indicator is lit.
Press
or
to adjust the
❒
respective volume levels.
Holding down either button will
increase or reduce the volume
levels continuously.
Notes
• The lowest two Level Indicators are lit in
the default volume settings.
• The remote control will revert to
MASTER volume mode if left idle for
some time.
• For your own safety, reduce the volume
level in MASTER volume mode before
switching the system to standby mode.
Adjusting subwoofer or treble levels
To adjust subwoofer levels, press
❒
the SELECT button until the
SUB mode indicator is lit.
To adjust treble levels, press the
❒
SELECT button until the
TREBLE mode indicator is lit.
❒
Press
or
to adjust the
respective levels.
Holding down either button will
increase or reduce the levels
continuously.
General Notes
• In the default subwoofer and treble
settings (flat response), the lowest three
Level Indicators are lit.
• Pressing
boosts the levels, and causes
more Level Indicators to be lit. Pressing
reduces the levels, and causes fewer
Level Indicators to be lit.
Advertisement
