Advertisement
4
SEALANT
INSTALL WAX SEAL
Invert toilet on floor (cushion to prevent
damage), and install wax ring evenly around
waste flange (horn), with tapered end of ring
facing toilet. Apply a thin bead of sealant
around base flange.
6
BOLT CAP
CLOSET BOLT
WASHER
NUT
INSTALL TOILET
a. Position toilet squarely to wall and, with a
rocking motion, press bowl down fully on
wax ring and flange. Alternately tighten
nuts until toilet is firmly seated on floor.
!
CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b. Install caps on washers. (If necessary, cut
bolt height to size before installing caps.)
c. Smooth off the bead of sealant around
base. Remove excess sealant.
8
INSTALL TOILET SEAT
5
WAX RING
POSITION TOILET ON FLANGE
a. Unplug floor waste opening and install toilet on closet flange
b. Loosely install retainer washers and nuts. Side of washers
7a
TANK MTG.
BOLTS PRE-
INSTALLED
CLOSET FLANGE
INSTALL TANK
a. Install large rubber gasket
over threaded outlet on bottom
of tank and lower tank onto bowl
so that tapered end of gasket fits
evenly into bowl water inlet
opening, and tank mounting
bolts go through mounting holes.
Secure with metal washers and
nuts.
b. With tank parallel to wall,
alternately tighten nuts until tank
is snugged down evenly against
bowl surface.
DO NOT OVERTIGHTEN NUTS MORE
THAN REQUIRED FOR A SNUG FIT!
Install toilet seat in accordance with manufacturer's directions.
so bolts project through mounting holes.
marked "THIS SIDE UP" must face up!
For Tanks/Bowls using Speed
Connect System (Tank
mounting bolts pre-installed).
RUBBER
GASKET
WASHER
NUT
!
CAUTION:
- 2 -
NUT
CLOSET
BOLT
FLANGE
7b
For all other Tanks/Bowls
TANK MTG.
BOLTS
WASHER
NUT
INSTALL TANK
a. Install large rubber gasket
over threaded outlet on bottom
of tank and lower tank onto bowl
so that tapered end of gasket fits
evenly into bowl water inlet
opening.
b. Insert tank mounting bolts
and rubber washers from inside
tank, through mounting holes,
and secure with metal washers
and nuts.
c. With tank parallel to wall,
alternately tighten nuts until tank
is snugged down evenly against
bowl surface.
!
CAUTION:
DO NOT OVERTIGHTEN NUTS MORE
THAN REQUIRED FOR A SNUG FIT!
730237-100 Rev. U
TAPERED
WASHER
RUBBER
WASHER
RUBBER
GASKET
Advertisement
