Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
COLONY 2388 / 2399 / 2359
COMPACT 2149.012
RENAISSANCE 2241
RENAISSANCE RF Total Toilet 2444
RENAISSANCE EL Total Toilet 2446
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years.
To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local codes.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Regular Screwdriver
Hacksaw
Flexible Supply Tube
Sealant
Carpenters Level
1
REMOVE OLD TOILET
a.
Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b.
Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c.
Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d.
Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
2
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must
be as listed below:
For 4010.010/4310.016 Tanks: A = 254mm (10")
For 4014/4314 Tanks: A = 356mm (14")
For 4010.012 and all other Tanks: A = 305mm (12")
For 4037.017 Tanks: A = 305mm (12")
For 2444/2446 Complete Toilet: A = 305mm (12")
FINISHED WALL
A
Prod uct n ame s li ste d h e r ei n ar e tra d ema rks of Am eri ca n Standa rd In c .
© American Stan d ar d In c. 20 0 6
Adjustable Wrench
Tape Measure
SUPPLY
AS
REQ'D.
FINISHED
FLOOR
Wax Ring/Gasket (
included in 2444/2446)
Closet Bolts (
included in 2444/2446)
Seat (
included in 2444/2446)
3
CLOSET
FLANGE
CLOSET
BOLTS
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90°,
and slide into place 6" (152 mm) apart and
parallel to wall.
A
Saniwares
730237-100 Rev. U
Advertisement
Related Manuals for American Standard Renaissance RF Total Toilet 2444
Summary of Contents for American Standard Renaissance RF Total Toilet 2444
- Page 1 RENAISSANCE RF Total Toilet 2444 RENAISSANCE EL Total Toilet 2446 Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin.
- Page 2 WAX RING SEALANT INSTALL WAX SEAL Invert toilet on floor (cushion to prevent damage), and install wax ring evenly around waste flange (horn), with tapered end of ring facing toilet. Apply a thin bead of sealant around base flange. BOLT CAP CLOSET FLANGE CLOSET BOLT WASHER...
-
Page 3: Repair Parts List
TANK WATER INLET WASHER FLEXIBLE COUPLING NUT SUPPLY VALVE NUT COMPRESSION COLLAR TRIM PLATE VALVE CAUTION: Overtightening of COUPLING NUT could result in breakage and potential flooding. CONNECT WATER SUPPLY Connect water supply line between shutoff valve and tank water inlet fitting. - Page 4 WARNING: Do not use in-tank cleaners. Products containing chlorine (calcium hypochlorite) can seriously damage fittings in the tank. This damage can cause leakage and property damage. American Standard shall not be responsible or liable for any tank fitting damage caused by the use of cleaners containing chlorine (calcium hypochlorite).
-
Page 5: Troubleshooting Guide
This warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty maintenance, abuse, misuse, accident or other damage; if it was not installed in accordance with American Standard's instructions; or if it has been modified in a manner inconsistent with the product as shipped by American Standard.