Table of Contents
Advertisement
GETTING STARTED
Power on/off
To turn the power on
Press the power on/off switch. The blue power indicator will blink quickly while the LAMP is preheating. After
ten seconds (*1), the power indicator will stay on and the picture will start to appear. The picture will become
normal after another 50 seconds.
POWER indicator
LAMP indicator
TEMP indicator
*
1 With the special operation or something wrong occurs to the lamp, the blinking will prolong.
When the set is on standby
If the set is turned off by pressing the
become dark after two minutes slow blinking (lamp is cooling ) , then the set is entering standby mode
indicating the TV is not turned off completely when it is in slight power consumption mode and waiting for
your new command.
You can turn on the set using the
appear after the power indicator quick blinking (the lamp is preheating). The picture will become normal in 50
seconds. You can also press the program CH +/- buttons on the front panel to turn on the set.
To turn power off
1. Put the set in standby mode, first.
Press the
button on the remote control unit, the power indicator will become dark after two minutes
slow blinking (lamp is cooling ), then the set will enter standby mode.
2. Then turn off the power.
Be sure that the power indicator becomes dark after slow blinking, then press the set power on/off switch to
turn off the power.
Notes :(1)Please follow the above steps to prolong the lamp life. Avoid turning off the power directly.
(2)You can press the power on/off switch to cut the power supply directly in times of
emergency only.
(3)Failure to follow the correct operating and shutdown procedures may damage the lamp
and void the warranty.
Note : If you are not going to use the set for a long time, turn off the power on/off switch
blink quickly
Lamp is preheating
blink slowly
Lamp is cooling
on(dark)
On standby
on(bright)
Power on
on
Lamp going out
blink
Lamp's door being opened
on
Lamp overheating
blink
Fan stopping
button on the remote control unit in standby mode. The picture will
and disconnect the plug from the power outlet.
Temperature indicator
Power indicator
Power on/off
Lamp indicator
switch
Please contact a service technician for
inspection or repairing.
button on the remote control unit, the power indicator will
12
Remote control sensor
Advertisement
Table of Contents
