Snmp - EnGenius EOC-3610s-EXT User Manual

11b/g Wireless Outdoor Multi-Client Bridge/AP Version 1.0
Transmit Power: You may control the output power of the device by selecting a
value from the drop-down list. This feature can be helpful in restricting the coverage
area of the wireless network.
Layer 2 Isolation: Place a check in this box if you would like to enable the layer 2
isolation feature. This feature will hide the node from the windows network
neighborhood. It is recommended to enable this feature in a hotspot environment.
WDS: Place a check in this box to enable WDS (Wireless Distribution System).
When WDS is enabled, this access point functions as a wireless repeater and is able
to wirelessly communicate with other APs via WDS links.
Note that WDS is incompatible with WPA -- both features cannot be used at the
same time. A WDS link is bidirectional; so this AP must know the MAC Address
(creates the WDS link) of the other AP, and the other AP must have a WDS link back
to this AP. Make sure the APs are configured with same channel number.
WDS AP MAC Address: Specify one-half of the WDS link. The other AP must also
have the MAC address of this AP to create the WDS link back to this AP.
Click on the Save Settings button once you have modified the settings.

4.3.3 SNMP

Click on the SNMP link under the Wireless menu. This page allows you to SNMP
community and trap settings. The feature is useful while remotely monitoring and
marinating the device.
SNMP Daemon: Select Enable if you would like to use the SNMP feature.
Read-Only Community Name: Specify the password for access the SNMP
community for read only access.
Read-Write Community Name: Specify the password for access to the SNMP
community with read/write access.
Send SNMP Trap: Select Enable if you would like to receive SNMP traps.
Send Trap To: Specify the IP address that would receive the SNMP traps.
Trap Community Name: Specify the password for the SNMP trap community.
Click on the Save Settings button once you have modified the settings.
44