Ebattery Charging; F Assembly - Power Wheels Ford Mustang Owner's Manual With Assembly Instructions

J4390, j9561, j9562
Table of Contents

Advertisement

E
BATTERY CHARGING
• Plug the charger connector into the battery
• Plug the charger into a standard wall outlet
Notes:
- If power flow to the wall outlet is controlled by a switch, make sure
the switch is "ON".
- Use the charger only in a wall outlet. Do not plug the charger into a
ceiling outlet.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of your
vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the battery connector from
the charger connector. Unplug the charger from the wall outlet. The
battery is now ready to be installed in your vehicle. Please see the
Battery Installation section on page 12 for detailed instructions on
installing your battery. If your battery is already installed in your
vehicle, simply re-connect the motor harness connector to the battery.
8
B
A
Charger
Connector
A
.
.
B
ASSEMBLY
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children should
not handle parts, including the battery, or
help in assembly of the vehicle.
1
BOTTOM VIEW
• Place the vehicle upside down.
• Slide the bumper support, ribbed side up, into the slot in the front
end of the vehicle.
• Insert two
1
/
" x 1
1
/
" screws into the bumper support and tighten.
4
4
Bumper Support
C3493pr-0921
J4390pr-0920
F

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ford mustang j4390Ford mustang j9561Ford mustang j9562

Table of Contents