Connecting The Terminal; Terminal Screens - Comtech EF Data Radyne DM240XR Installation And Operation Manual

DM240XR High-Speed Digital Modulator

4.8.1 Connecting the Terminal

1. Connect the Terminal to the Terminal Connector (J1) on the rear of the unit using the RS-
232 null modem Cable.
2. Verify that your emulation software is set to the following:

8 data bits

no parity

1 stop bit

No Flow Control
Modify the selection, if necessary, to match the settings (the Front Panel 'SYSTEM' Sub-
Menu contains all the Terminal Emulation Controls).

4.8.2 Terminal Screens

Note: The GIG Ethernet Terrestrial Card is only displayed when the Ethernet Data Interface is
installed.
MN-DM240XR– Revision 12
Figure 4-5. Main Menu
User Interfaces
4–42