LG SolarDOM MP-9485S Service Manual page 21

COMPONENTS
FUSE
H.V. FUSE
HEATER ELEMENT
(Wire leads removed.)
MAGNETRON and OVEN
THERMOSTAT
TEST PROCEDURE
Check for continuity of the fuse with an
multi-meter.
NOTE: If the fuse is blown, check the primary, the secondary, and the monitor
switches, H.V.D. and H.V.C. before replacing the fuse.
If the fuse is blown by improper switch operation replace the defective switch
and the fuse at the same time. Replace just the fuse if the switches operate
normally.
Measure the resistance.
(Multi-meter scale: Rx1)
Measure the resistance with 500V-100M ohm
insulation resistance meter.
NOTE: Make sure heater is fully cooled when tested.
5-11
Normal
Normal:
• Upper sheath heater:
Approx. 47 ohm (230V, 1100W)
• Lower sheath heater:
Approx. 141 ohm (240V, 400W)
• Upper Halogen heater:
Approx. 15 ohm (230V, 450W)
(at 20 ~30°C)
Normal: more than 0.5 Mohm
OVEN Thermostat 0°C~160°C
M.G.T Thermostat 60°C~Approx.110°C
RESULTS
Abnormal
160°C
Over 110°C